W81-K
Joint flank profile-KWith edge for float-finish plaster and 12.5 cm mesh
The APU joint flank profile is used in compound heat insulation systems for flush plaster joints with existing structural components such as door and window elements and frames. It is put directly on top of the insulation at a distance from the structural element. The watertight seal (e.g., with a PUR sealing strip) is not included and must be done in ac- cordance with the respective manufacturer’s specifications on planning and dimensions. After completion of the plastering work the profile forms a flush, clean termination of the plaster. The profile contour enables the application of a thick layer of plaster / float-finish plaster.
The profile has a welded fabric strip. Each bar has a fabric overhang on one side of 10cm in the lengthways direction. The rear mounting wing has a wing width of 60 mm and can if necessary be shortened at one of the intended break points to 30 mm, 40 mm or 50 mm. The included plug connectors (Z14) connect the profiles as a flush joint in the area where the pieces abut. The corner is formed using prefabricated corner pieces (Z81-60-K). These are not included in the scope of delivery.
| Material |
|
| Mesh |
|
| Accessories |
|
| Optional accessories |
|
| Storage | Always store profiles laid down in a dry place. |
| Scope of delivery | The sealing tape/strip is not included with the product. |
| Other applications | Any applications not clearly described in the documents may be implemented only after consultation with the plaster or ETICS manufacturer. |
| Selection criteria | Adhere to the latest APU selection criteria. see APU selection criteria |
Sectional drawing in mm
Application drawing
