Expansion joint profile MOVIWith TPE expansion joint tape and 12.5 cm mesh

Die APU-Expansion joint profile MOVI W56

The APU expansion joint profile MOVI is used in compound heat insulation systems at building joints. For the flush formation of a clean plaster edge, the profile can fitted both in flat surfaces and inner corners.

The profile is made up of 2 plastic profiles, to each of which a strip of mesh is welded. Between the two profiles there is a soft expansion joint tape made of flexible TPE, which can absorb the movements. Thanks to it being possible for the profiles to move, they can be fitted overlapping in areas where elements abut. The abutting joint must then have ap- propriate PUR sealing strip fitted behind it and thus be sealed off. After completion of the plastering work and removal of the protective film, a clean plaster division is produced.


Expansion joint profile MOVI, With TPE expansion joint tape and 12.5 cm mesh
Length2.0 m
Packaging unit25 bars = 50 m
Weight (per PU)10.0 kg


  • Rigid PVC manufactured under DIN-16941
  • TPE manufactured under DIN-16941
  • Min. 160 g/m2 approved for compound heat insulation systems
  • 2 x 12.5 cm wide – MW 4 x 4 mm
  • Ultrasonic welded
Movement absorbed on surface area
  • c. 15 mm
  • (stretchable by c. 10 mm, compressible by c. 5 mm)
Movement absorbed in internal corner
  • c. 15 mm
  • (stretchable by c. 10 mm, compressible by c. 5 mm)

Important notes

StorageAlways store profiles laid down in a dry place.
Other applicationsAny applications not clearly described in the documents may be implemented only after consultation with the plaster or ETICS manufacturer.
Abutting joint sealThe abutting joints must in addition have appropriate PUR sealing strip fitted behind them and be sealed off.


Sectional drawing in mm


Application drawing

Your watchlist is empty